For sale is a Kohler 10CCE61 10KW 1PH 120/240V Truck-Mounted Gas Generator w/ Fenex Controller and a couple small hose reels. Here is what I know about this unit and the back-story: This was on a 1997 F350 service truck. It was fueled by the gas tank on the truck. The generator has its own fuel pump but not it’s own fuel tank so you’ll need to plumb the fuel line from the generator into a fuel tank. When I got this, the starter did not work. I put a brand new starter on it and it starts and runs. I plugged the Fenex controller into it and plugged in a 120v corded drill. I got power and the drill functioned. I did not test 240v so I don’t know about the 240v functionality. Also the volt meter on the controller showed around 120v when running. Some of the features on the Fenex controller seem to work, some don’t. So you’ll want to go through the controller, if you want to use it, to see what works and what needs attention. As for the generator, it starts and runs. It’s ran by a Ford VSG-4111 4 cylinder gas engine. If I understand my research correctly, it’s suppose to have an automatic throttle control feature on it that is suppose to keep the engine around 1800rpm. I think that mechanism might need some attention but I’m not sure. I just don’t know enough about this unit. The automatic throttle mechanism seems to be a little rusty so I think it might need cleaned. I was able to sort of manually mess with the throttle. If I rev’d it up high, it would flash a red light and die. From what I read, it has a “high RPM” feature that will kill the engine to prevent harm if the engine goes over a certain rpm. So that feature seems to work. As for cosmetics, it’s obviously not perfect. A little cleaning and some paint would go a LONG way with this generator. From what I read, these generators are known to last a VERY long time. This is all I know about this unit. Email me any questions you may have and I’ll answer to the best of my ability. If you are familiar with these generators or know someone that is, this might be a good unit for you. It just needs someone that can go thru it to make sure everything is how it needs to be. Shipping to the lower 48 states only due to size and weight. No shipping to Alaska, Hawaii, Puerto Rico, or any other US Territory. No international shipping. Shipping will be via FedEx freight at the cost of $750. If you are local, pickup is free. I have a forklift and I can load for you. The frame that the generator and controller are sitting on in the picture is not included. The generator is bolted to it with just a few bolts. It will be removed, and the generator and Fenex controller will be strapped to a pallet for shipping.